Page
4
10.
The next screen displays the operating frequency of the group/channel.
If there is no frequency currently stored in the selected users
group/channel, a dashed line will be shown. Press SET. The dashed line
or frequency will start flashing. Press the up arrow one step at a time to
find the desired frequency or hold down the up arrow to scroll through
the frequencies quickly. The frequencies can be scrolled either way by
the up/down buttons. When the desired frequency is showing, press SET.
11.
Press the set and down arrows at the same time then release to go to the
next screen function.
12.
The next screen shows the battery level in % (percent). Press the set and down
arrows at the same time then release to go to the next screen.
13.
The next screen shows the audio setting. The display is shown in dB.
0 dB is (maximum volume), -27 dB is (minimum volume). Press the set
and down arrows at the same time then release to go to the next screen.
Setting the attenuator for the maximum Audio Meter reading on the
receiver without peak distortion will produce the best signal to noise
ratio.
14.
The next screen shows the transmitter RF level (Lo or Hi). Press the Set
button if you wish to change the RF level. Press the up button to go to
Hi or the down button to go to Lo. Press Set to store.
The transmitter RF is normally shipped set to “Lo” for use with
multiple frequency systems and the best battery life.“Hi power can be
selected for longer distances or to suppress noise or interference. The
nominal power in Hi is 50 milliwatts.
15.
Press the set and down arrows at the same time then release to go to the
next screen function, which will return to the Gp/Ch screen. The
display screen will automatically show the Gp/Ch screen when the
transmitter is first turned on.
16.
When power off is required, simply place the power Off-On switch in the OFF
position. The display will then delay slightly to allow the receiver to shut down
quietly.
