4. Tighten all four screws securely.
Installing the antenna cables
Notice!
Mount the rack ears to each side of the re-
ceiver pair prior to installing the antenna ca-
bles.
To install the antenna cables, do the following:
1. Locate a CXUF rear to front antenna cable and
determine the cable end containing a threaded
flange-mount connector.
Two CXUF cables are in the kit.
2. Remove the locking nut, lock washer, and rubber
insulator ring from the threaded flange-mount
connector.
3. Align the flat (A) portion of the threaded connector
barrel with the flat portion of the rack ear front flange
opening, slide the threaded barrel through the
opening until it is fully extended through the rack ear
flange.
FLAT (A)
CXUF
4. Slide the rubber insulator ring onto the threaded
connector barrel.
5. Slide the lock washer onto the threaded connector
barrel.
6. Thread and tighten the nut onto the threaded
connector barrel.
Ensure the nut is tightened securely to the connector
barrel.
7. Repeat steps 4-6 for the other cable and rack ear.
8. Connect the other ends of the antenna cables into
antenna A and antenna B inputs of the receiver or an
antenna distribution device.
Antenna distribution device options: RE3-ACC-AASP
active antenna splitter or the RE3-ACC-PASP passive
antenna splitter.
When assembled without antenna mount, the
assembly should appear as shown.
Assembled without antenna mounts
Replacement parts
Order number
Description
ESP-EF01U362356
RKMT antenna hole plugs RE3 (2pcs)
Compatible products
Order number
Description
RE3-ACC-AASP
2-in x 8-out antenna splitter 470-960MHz
RE3-ACC-PASP
1 x 2 passive antenna splitter kit
RE3-ACC-RFAMP
Active RF antenna booster; 470-960MHz
RE3-ACC-PLPA
Passive log periodic antenna; 470-960MHz
RE3-ACC-ALPA
Active log periodic antenna; 470-960MHz
RE3-ACC-CXU2
2 foot antenna coax cable (pair)
RE3-ACC-CXU10
10 foot, 50 ohm BNC coax cable (pair)
RE3-ACC-CXU25
25 foot, 50 ohm low loss BNC coax cable
RE3-ACC-CXU50
50 foot, 50 ohm low loss BNC coax cable
RE3-ACC-CXU75
75 foot, 50 ohm low loss BNC coax cable
RE3-ACC-CXU100
100 foot, 50 ohm low loss BNC coax cable
Parts included
Quantity
Component
2
Rack ears
2
CXUF front mount antenna cables
2
Plastic hole plugs
4
Mounting screws
1
Engineering datasheet
1
Warranty and product documentation information
card
Ordering information
RE3-ACC-RMK1 Rack mount kit for single RE3 receiver
Rack mount kit for rack mounting RE3 receivers, black
Order number
RE3-ACC-RMK1
2 | RE3-ACC-RMK1 Rack mount kit for single RE3 receiver
