Mb200/Mb200W Installation Kit
Mb200/Mb200W Installation Kit
2
M
b
200 SPECIFICATION GRAPHICS
FIGURE 1 —Attaching M
b
200 Bracket
to System 200
TM
Speaker (exploded view)
22.90 in. (582 mm)
0.33 in. (8 mm)
3.69 in. (94 mm)
2.75 in. (70 mm)
8.0 in.
(203 mm)
8.0 in.
(203 mm)
5.0 in. (127 mm)
HOLE PATTERN FOR OmniMount
LOCATED ON BOTH SIDES AND BACK
®
0.33 in. (8 mm)
0.33 in. (8 mm)
0.5 in. (13 mm)
3/8–24
10.87 in. (276 mm)
24.90 in. (632 mm)
Wall Mounting Instructions
CAUTION: Due to the weight of System
200
TM
speakers, it is imperative that the
M
b
200 bracket be properly secured to the
wall or ceiling. The choice of fastener (not
provided with this kit) will be determined
by the material and construction of the
mounting surface.
1.
Refer to Figure 1 for the following steps.
2.
Remove the paper backing from one of
the friction pads (F) and, making sure the
holes are aligned, attach to the U-bracket (A)
as shown. Attach the second friction pad in
a similar manner.
3.
Attach the U-bracket to the wall or ceil-
ing using fasteners (not supplied) that are
suitable for the construction material.
4.
Remove the hole plugs from the ends of
the System 200
TM
speaker by gently prying
with a small screwdriver.
5.
Place one of the smaller lock washers
(C) on each of the two M8 bolts (B).
6.
Place the speaker into the U-bracket and
finger tighten the M8 bolts.
7.
Rotate the speaker so that the input
panel is accessible and attach the wires to
the input panel.
8.
Position the speaker for the desired cov-
erage and gently tighten the M8 bolts until
the speaker will no longer rotate. DO NOT
OVERTIGHTEN.
Note: The
3
/
8
-24 bolts (D) are used to
lock the speaker parallel to the bracket and
prevent it from being rotated. This is needed
when arraying the speaker for proper align-
ment and when flying in the vertical posi-
tion.
Flying Instructions
NOTE: A maximum of two speakers can
be suspended together vertically using the
M
b
200 installation bracket.
1.
Refer to Figure 1 for the following steps.
2.
Remove the paper backing from one of
the friction pads (F) and, making sure the
holes are aligned, attach to the U-bracket (A)
as shown. Attach the second friction pad in
a similar manner.
3.
Remove the hole plugs from the ends of
FIGURE 2 — M
b
200 Installation Kit Dimensions
FIGURE 3 — Wall-Mounting a System 200
TM
Speaker
Using the M
b
200 Installation Kit
1
1. OmniMount is a registered trademark of OmniMount
Systems, Inc.
