Electro-Voice EVOLVE50-TB, Руководство пользователя

Страница: 30 / 44

30 en | Mixer operation EVOLVE Portable Column Loudspeaker
2021-04 | v04 | F.01U.393.750
User manual
Electro-Voice
AUX control
The AUX control is primarily meant for establishing an independent mix, e.g. for monitor or a
second room/zone. The individual channel AUX controls will determine the amount of each
channel's post fader signal present at the AUX output if AUX OUT is set to AUX MIX.
COMP control
During operation, the input signal processing can be adjusted by using the COMP control to
control the on board compressor. Compressors are available on INPUTS 1-4. Adjust the
COMPRESSOR threshold and compression ration simultaneously using the COMP adjustment.
As the
COMP control is adjusted from 0 to 100, the gain below the threshold will increase
from 0 to 10 dB and the compression ratio will increase from 1:1 to 8:1. The compressor will
reduce the dynamic range of the audio signal proportional to the compressor setting. Once
the signal exceeds a certain threshold, the signal gets compressed, i.e. major input level
changes result in minor output level changes. Narrowing the dynamic range often allows for
easier recording or mixing the audio signal. It is recommended to start with low to moderate
levels of compression (25-40) and increase slowly if necessary.
6.2 QuickSmart Link configuration
With QuickSmart Link you can combine all input signals from 2 EVOLVE50M loudspeakers into
one mixer. The mixer output signal can be Mono or Stereo, the signal routing is set during the
configuration process.
1.
Make sure both EVOLVE 50M systems are turned on.
2. Connect the network cable to the QuickSmart link port on each EVOLVE 50M system.
3. Configuration is completed through the QuickSmart DSP control menu displayed on the
LCD of either EVOLVE 50M system. Choose one EVOLVE 50M system to complete the
configuration.
4. The LCD will display that the QuickSmart link is detected.
5. You will need to determine how to synchronize parameters between both EVOLVE 50M
systems. The LCD will display "parameter Sync Send or Receive".
6. If you wish to copy and send parameters from the EVOLVE 50M system you are
controlling, select "send".
7. If you wish to read and copy the parameters from the second EVOLVE 50M system, select
"receive".
8. The LCD will display a message asking if the EVOLVE 50M system you are controlling
should be configured for Stereo L, Stereo R or Mono signals.
9. Select the appropriate signal. The second EVOLVE 50M system will automatically be
configured based on your selection.
10. The LCD will then display that the QuickSmart Link is ready.
With QuickSmart Link, several parameters of the connected EVOLVE 50M systems are linked.
(i.e. changing a parameter on one EVOLVE 50M system will trigger an equivalent change on
the 2nd EVOLVE 50M system) This ensures the system parameters are consistent and results
the best acoustic performance.
Linked parameters are:
–
System volume
– Function
– Mode
– System and Subwoofer Delay
– Speaker EQ (Bass, Mid, Treble)
– SPK OUT, MIX OUT and AUX OUT routings
– Main GEQ