09/17/2014
BI308
Electric
Mini-Boiler
™
HI TEMP MODEL
Installation & Operating
Instructions
EMB-H-5
240-volt, 1-stage
30A CB
4.5 kW
15,000 Btu/h
EMB-H-7
240-volt, 2-stage
45A CB
7 kW
24,000 Btu/h
EMB-H-9
240-volt, 2-stage
60A CB
9 kW
31,000 Btu/h
Application –
This Electro-Boiler is factory equipped with
WarmFlo
smart controller.
WarmFlo
automatically regulates outlet water temperature based upon preset, front panel, temperature selection. This
model does not have an outdoor sensor and is not programmed for outlet temperature ramping (outdoor reset
concept). If your application is “outdoor reset”, you should consider using model EB-MO series.
Primary application is any hydronic water heating system (high or low temperature systems) where reduced
flow or radiation can cause overheat conditions (example, zones).
However
, if it is a mixture of large and small
zones, the sudden capacity and flow changes may cause some internal timing/over temp conditions.
This series is equipped for load management interrupt and can apply to standard baseboard radiation, dual heat
combinations, under floor radiant, wood boiler supplement, etc.
Accessories –
Attached BL001 lists various accessory or option items which are not part of basic Electro-Boiler.
Note:
This product meets the requirements of the ASME Boiler and Pressure
Vessel Code.
Drawings: BX305
BH310
UAW411
BL001
XX017
