8
–
PRESETS
–
The STM has nine fully programmable presets. Saving a preset will capture the
setting of each of the five black knobs and the auxiliary function settings. Once a
preset is saved, the STM will remember its settings after power has been
disconnected. You may write the name of the preset in the white painted block that
each number is located in; we recommend dry erase marker.
Preset Save Procedure
1.
Once you have created a sound you want to save or if you want to save an
edited preset, turn the PRESETS knob to light the preset LED number
where you want to save the setting to.
2.
Press down and hold the PRESETS knob for 3 seconds. The LED ladder will
blink to indicate save completion.
3.
After the LEDs stop blinking, release the PRESETS knob. The PRESET LED
will light up solid.
4.
Your preset is now saved.
Preset Load Procedure
There are two options for loading presets:
A.
Press and release the PRESET footswitch repeatedly until the preset you
want to load is selected. Make sure the PRESET LED is lit to indicate your
preset is loaded.
Please Note:
The current knob positions are no longer
valid.
B.
Use the PRESETS knob and the PRESET footswitch.
1.
Turn the PRESETS knob so the preset number where the preset was
saved is selected.
2.
Press and release the PRESET footswitch. The PRESET LED will light up
to indicate that the preset is loaded.
Please Note:
The current knob
positions are no longer valid.
Upon loading a preset, an LED in the LED ladder will blink briefly indicating the
VOICE mode that was recalled with the preset. After loading a preset, if you move a
knob, the knob’s new location will supersede the preset’s stored value for that knob.
At this point, the PRESET LED will blink rapidly to indicate that a knob has been
moved, though a preset is still loaded.
Preset Unload Procedure
A preset can be unloaded to restore the current knob positions. Turn the PRESETS
knob clockwise until no LEDs in the LED ladder are lit to unload the current preset
and restore the sound to the current knob settings. This will also revert the auxiliary
functions to their prior, non-preset settings. If Preset 9 is loaded, upon pressing the
PRESET footswitch, the STM will cycle back to the unloaded setting, where no preset
is loaded. Press the PRESET footswitch again and Preset 1 will load.
Factory Preset Restore Procedure
1.
Press and hold down the PRESETS knob and the PRESET footswitch while
applying power.
2.
After applying power, continue to hold down both switches until you see
the LED ladder blink rapidly. At this point you can release the switches; the
factory presets have been restored.
