SPARE LAMP
reference : ELKC212ET-TU
ELKC212ET
Insect Destroyer
Operating instructions
Read carefully before use
Thank you for purchasing the ELECTRIS INSECT
DESTROYER.
We are confident that this device will give complete
satisfaction.
Warning:
Getting started:
Unpack the product. Once the insect destroyer is installed, connect the
power cord located at the back to a 230V power outlet and press the on/off
switch (I/0).
When switched on, the tubes emit a bluish ultraviolet light. Flying insects
are attracted to this light and touch the electric mesh. The contact of the
insect with the grid electrocutes it and can sometimes cause small sparks.
Similarly, sometimes, at the first power up, it is possible there is a risk of
electric arc at the tubes which will not reproduce there after.
Maintenance:
Before any intervention, disconnect the device
and leave it to cool for about 15 minutes.
Keep the device in a dry, ventilated, dust-free place.
Clean the dead insects off the wire mesh using
a small brush at least once a week.
In the lower part of the insect destroyer, a removable
container collects the insects.
This container must be emptied and cleaned at least once a week.
Changing the neon (tube):
Check that the device is disconnected. On the back of the unit, remove the
screws and open the two fasteners on each side of the top of the outer
mesh. Unlock the neons and replace them with new ones.
Close the mesh properly.
Puissance : 6 W
Culot : G5
Dimension :
Ø15mm, long. 210 mm
Éclairage UV
Par 1 pièce
Risk of electrical shock
Electric protection class: Class I
Degree of protection against humidity: IPX0
This equipment can be used by children aged 8 years and over and by
persons with reduced physical, sensory or mental abilities or without
experience or knowledge, if they are properly supervised or if instructions
on the safe use of the equipment have been given to them and the risks
involved have been understood. Children should not play with the device.
Cleaning and maintenance by the user must not be carried out by
unattended children. Never immerse the device in water.
It must be kept out of
the reach of children
by fixing it at
a height of at least 2 meters from the
ground below the device.
Stabilise it at a height using the chain provided.
Always keep the device, cord and plug away from moisture.
Do not hang or lift the device by the power cord.
At the slightest incident, unplug your device.
The device can only be used indoors:
use in barns, stables and
similar premises is not considered as indoor use. Do not use in a bathroom.
It must not be used in areas where flammable vapours or explosive dust are
likely to be present. If the power cord is damaged, it must be replaced by
the manufacturer, its After-sales department or any other similarly qualified
person in order
to reduce the risk of electric shock.
Specifications:
Power cord: 1 m
Fastening chain and associated clips
2 x 6 Watt fluorescent tubes
1 Electronic ballast for fluorescent tubes
1 High voltage electronic circuit
This insect destroyer effectively eliminates flying insects WITHOUT CHEMICALS.
The light emitted by the two ultraviolet tubes attracts insects to the internal high
voltage mesh (1000 V at a few milli-Amperes) to electrocute them.
RESPECT THE HEIGHT OF
AT LEAST 2 METRES
Coverage area: 20 m2
Direct power supply 230 Volts ~50/60 Hz
Consumption: 11 Watts
Weight: 1100 g
Dimensions: 27 x 25,5 x 8,5 cm
4
5
SPARE LAMP
reference : ELKC212ET-TU
ELKC212ET
Insect Destroyer
Operating instructions
Read carefully before use
Thank you for purchasing the ELECTRIS INSECT
DESTROYER.
We are confident that this device will give complete
satisfaction.
Warning:
Getting started:
Unpack the product. Once the insect destroyer is installed, connect the
power cord located at the back to a 230V power outlet and press the on/off
switch (I/0).
When switched on, the tubes emit a bluish ultraviolet light. Flying insects
are attracted to this light and touch the electric mesh. The contact of the
insect with the grid electrocutes it and can sometimes cause small sparks.
Similarly, sometimes, at the first power up, it is possible there is a risk of
electric arc at the tubes which will not reproduce there after.
Maintenance:
Before any intervention, disconnect the device
and leave it to cool for about 15 minutes.
Keep the device in a dry, ventilated, dust-free place.
Clean the dead insects off the wire mesh using
a small brush at least once a week.
In the lower part of the insect destroyer, a removable
container collects the insects.
This container must be emptied and cleaned at least once a week.
Changing the neon (tube):
Check that the device is disconnected. On the back of the unit, remove the
screws and open the two fasteners on each side of the top of the outer
mesh. Unlock the neons and replace them with new ones.
Close the mesh properly.
Puissance : 6 W
Culot : G5
Dimension :
Ø15mm, long. 210 mm
Éclairage UV
Par 1 pièce
Risk of electrical shock
Electric protection class: Class I
Degree of protection against humidity: IPX0
This equipment can be used by children aged 8 years and over and by
persons with reduced physical, sensory or mental abilities or without
experience or knowledge, if they are properly supervised or if instructions
on the safe use of the equipment have been given to them and the risks
involved have been understood. Children should not play with the device.
Cleaning and maintenance by the user must not be carried out by
unattended children. Never immerse the device in water.
It must be kept out of
the reach of children
by fixing it at
a height of at least 2 meters from the
ground below the device.
Stabilise it at a height using the chain provided.
Always keep the device, cord and plug away from moisture.
Do not hang or lift the device by the power cord.
At the slightest incident, unplug your device.
The device can only be used indoors:
use in barns, stables and
similar premises is not considered as indoor use. Do not use in a bathroom.
It must not be used in areas where flammable vapours or explosive dust are
likely to be present. If the power cord is damaged, it must be replaced by
the manufacturer, its After-sales department or any other similarly qualified
person in order
to reduce the risk of electric shock.
Specifications:
Power cord: 1 m
Fastening chain and associated clips
2 x 6 Watt fluorescent tubes
1 Electronic ballast for fluorescent tubes
1 High voltage electronic circuit
This insect destroyer effectively eliminates flying insects WITHOUT CHEMICALS.
The light emitted by the two ultraviolet tubes attracts insects to the internal high
voltage mesh (1000 V at a few milli-Amperes) to electrocute them.
RESPECT THE HEIGHT OF
AT LEAST 2 METRES
Coverage area: 20 m2
Direct power supply 230 Volts ~50/60 Hz
Consumption: 11 Watts
Weight: 1100 g
Dimensions: 27 x 25,5 x 8,5 cm
4
5