ElectrIQ eiQODGAG, Руководство пользователя, Страница: 18 / 19

18
TROUBLESHOOTING
PROBLEM CONDITION FIX
Pilot won’t light
Cylinder valve is closed Open valve
Blockage in orifice or pilot tube Clean or replace orifice or pilot tube
Air in the gas line
Open gas line and bleed it (pressing
control dial in) for not more than 1-
2 minutes or until you smell gas
Low gas pressure Gas cylinder low or empty
Ignition fails Change the Battery
Pilot won’t stay lit
Dirt build up around the pilot Clean dirt from around the pilot
Connection between the
gas valve and pilot assembly is loose Tighten the connection and perform a
leak test
Bad thermocouple Replace the thermocouple
Burner won’t light
Gas pressure is low Replace the gas cylinder
Blockage in the orifice Clear the blockage
Control dial is not in the
"HIGH" position
Turn control dial to the "HIGH" position
Burner flame is low
Note: Do not operate
heater below 5
℃
(40
°F
)
Gas pressure is low Replace the gas cylinder
Tank is almost empty. Replace the gas cylinder
Supply hose is bent or kinked
Straighten hose and perform leak test on
the hose
Control dial is fully " ON"
Turn control dial to "OFF", let it cool to
room temperature and check burner and
orifices for blockage
Emitter glows uneven
Note: Bottom 2.5cm of
emitter does not
normally glow
Gas pressure is low Replace the gas cylinder
Base is not on a level surface Place heater on a level surface
Heater not level Level the heater
Carbon build-up
Dirt or film on
the reflector and/or emitter
Clean the reflector and emitter
Thick black smoke Blockage in burner
Turn the control dial to the OFF position, let
it cool to room temperature and remove
blockage and clean burner inside and
outside.