13
OPERATING INSTRUCTIONS
BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, GAS DELIVERY SYSTEM MUST BE
PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL DIAL ANTI-CLOCKWISE TO THE
PILOT SETTING. PRESS THE DIAL IN AND HOLD FOR 1 MINUTE BEFORE ATTEMPTING IGNITION.
BATTERY REPLACMENT
Remove the control dial. Install 1 AA battery. The negative end of battery goes in first, then replace the control dial.
LIGHTING THE PATIO HEATER
•
Check all connections prior to each use.
•
Turn on the gas supply at source.
•
Press and turn the control dial anti-clockwise to the
LOW
(small flame)
marking. You will hear a click and this will light the burner.
•
Keep control dial depressed for up to 30 seconds then release the
control dial.
•
If the gas fails to ignite, press and turn the dial clockwise to
OFF
before repeating the lighting steps.
•
Turn the dial further anticlockwise to the
LOW
position.
•
Adjust the heat by turning the dial from the
LOW
position to the
HIGH
position as required.
Note: it is possible to light the appliance using a long match by lighting the
burner through the ignition hole in the emitter screen.
RE-LIGHTING
•
Turn the Dial to the OFF position.
•
Wait 5 minutes, to let gas dissipate, before attempting to re-light burner.
•
Repeat the “Lighting” steps.
TO EXTINGUISH
•
Hold the dial down and turn clockwise to the OFF position
•
Turn off the valve on the gas cylinder or the regulator after use.
•
Disconnect the gas bottle and allow this appliance to cool before moving the appliance.
Note: After use, some discoloration of the emitter screen is normal. Turn off the regulator after use and allow
the appliance to cool before moving.
