Electricwingman FlightClub PROton, Руководство строителя

Страница: 16 / 20

www.electricwingman.com
Go to the CLI tab.
It is possible to copy and paste the recommended settings from the front screen
before connecting here, however we are going to change a little:
This is the current recommended settings:
Set dterm_lowpass_type = PT1 We have already set this on the filter tab, but by all
means do it again if you want
Feature AIRMODE This sets AirMode to be always on, as discussed above, this
makes landing very difficult, instead we have set it up on a switch
Feature ANTI We have set this up already
Feature DYNAMIC Again we have already set this up
Set gyro__stage2_filter_type = FAST_KALMAN type this in and press return
Set gyro_filter_q = 400
Set gyro_filter_r = 88 these are the recommended filter settings, however I have
had quads where these produce heat in the motors, I strongly recommend q = 300
and r=80, type the two lines in and hit return after each.
(note you can choose to use the recommended settings from butter flight, in the
majority of quads these have been fine, but do keep an eye on motor temp)
Type Save and hit return
Configuring ESCs – BLHeli32
To configure the ESCS we are going to use BLHeliSuite32. This is not the same
software as BLHeliSuite used for BLHeli or BLHeli_S. It can be downloaded from
here:
https://www.mediafire.com/folder/dx6kfaasyo24l/BLHeliSuite
Download it, unzip it and run the BLHeliSuite32.exe.