Electra AWAU-VBZE218-H11, Руководство по обслуживанию, Страница: 28 / 58

Service Manual – V BZE DCI 1-A.1 GB 12–2
CONTROL SYSTEM
12.1.2 Compressor Frequency Control
12.1.2.1 Compressor frequency setting
The Load calculation is done by each indoor unit controller, based on a PI control scheme which
is based on the difference between SPT and RAT.
ODU controller will decide the compressor frequency based on the total load from all the indoors.
Compressor frequency will be limited within following ranges:
Mode
Minimum Frequency (MinFreq) Maximum Frequency (MaxFreq) *
YBZE218 YBZE324 YBZE430 YBZE218 YBZE324 YBZE430
Cooling 15 15 15 110 110 110
Heating 15 15 15 110 110 110
* Maximum frequency is also decided by different indoor combinations.
12.1.2.2 Frequency Changes Control
Frequency change rate is 1 Hz/sec.
12.1.2.3 Compressor Starting Control
12.1.2.4 Minimum On and Off Time
Prohibit turning ON the compressor for 3 minutes after turning it off. (Except during deicing
protection)
Prohibit turning OFF the compressor for 7 minutes after turning it on (except protections required
immediate compressor stop)