Elecro Engineering H.R.UV-C SPA-PRO, Инструкция по установке и эксплуатации

Страница: 12 / 24

12
The controller is pre-programmed to dose two chemical types:
A. Hydrogen Peroxide / Active Oxygen / H
₂
O
₂
B. Liquid Chlorine
Part 1
To set the type of chemical: use the / buttons
until “DOSE CHEMICAL” is displayed, press the
O.K. button and then use the / buttons to choose:
A.
‘H2O2’ or
B.
‘CHLORINE’
Press the O.K. button to select
A. Dosing Hydrogen Peroxide (H
₂
O
₂
)
After selecting ‘H2O2’ in Part 1 the display will now show ‘H2O2 DOSE’ the
/ buttons select the
correct dosage volume in ml (millilitres)
– Refer to Table A for suggested H
₂
O
₂
dosing figures.
Once the correct dosage volume is displayed press the O.K button to confirm, the display will then show
‘H2O2 START’
You now need to enter the time that you would like the dosing to take place
–
NOTE: the time must be
entered in the 24-Hour format and the dosing will take place at this time every day (24-Hours).
NOTE
•
The time selected must be at a time when the main filtration pump will be running.
•
Once the desired time has been selected press the ‘O.K.’ button and the display will then
show ‘SAVED’.
•
If the dosing volume is set to 0.0 (ml) the peristaltic pump will remain off.
•
In the event of power loss: the programmed settings (dosing volume and dosing time) will
remain stored. If the power to the controller is switched off for longer than 3-Hours the
current time will need to be re-programmed, this is indicated to the operator by the clock
flashing.
Set Dosage Requirements
•
Please note: Dosage amounts are set in ml/day (millilitres per day).
•
Use the below reference table as a guide.
•
To calculate your pool volume, see page 20 at the rear of this manual.
Volume of Swimming Pool (m
3
) Dosing Amount (ml/day)
35 200
50 320
60 420
80 620
90 700
100 800
130 1040
150 1200
Table A
NOTE
•
The above table is based on dosing Hydrogen Peroxide (H
₂
O
₂
) with a 32% concentration
and a water temperature of 28⁰C.