KXAT2 Installation Instructions
Page 4 of 6
Remove the screw and lock washer shown in Figure 4. Note that a tab held by the screw holds the adjacent
KXBPF board in place. Take care not to dislodge the KXBPF board while installing the KXAT2 board in the next
step.
Figure 4. Removing Retaining Screw and Lock Washer.
Position the KXAT2 board as shown over the area of the KX2 RF module between the KXBPF board and
then end. Connector J1 on the KXAT2 board plugs into J1 on the RF module shown inFigure 4. When J1 is
properly mated the hole for the screw and washer will be aligned over the spacer.
Figure 5. Mounting the KXAT2 Board.
