5
6
④
⑤
⑥
1. Remove the Top Cover and the Water Tank Chamber from the Base. Remove and discard the
protective foam on top of the Floater found inside the base.
2. Replace the water tank onto the base by aligning the Elechomes LOGO with the power knob.
3. Fill the Water Tank Chamber with purified water or distilled water up to the Max Water Level
Line. Do not overfill.
DO NOT ADD WATER TO THE BASE.
4. Push the Essential Oil Tray to pop it out, add 3-5 drops of essential oil into the Aromatherapy
Cotton.
5. Plug into a electrical wall outlet.
6. Power Knob
：
Rotate the Power Knob to the right to adjust mist output from low to high.
Low mist mode is suggested while using the humidifier at night.
To turn unit Off completely, turn Power Knob to the left until it clicks.
Note: The mist strength is adjustable. If there is water around the machine during use, it means
that the humidity in the room is too high. Please adjust to appropriate mist strength.
1. When the product is running and you take out the water tank, it will automatically stop
spraying mis, and the indicator light will turns green to red. After the water tank is put back,
the product will automatically restart spraying mist.
2. When the water level is low, it will automatically stop spraying mist, and the indicator light
will turns green to red. The indicator light will turn back to green and the humidifier will
automatically resume spraying mist when you add enough water to the water tank.
Note: Lifting the water tank may not automatically shut down the humidifier when there is
no water in the water tank but the machine is still spraying. (the status indicator light is still
green, and the atomizer is spraying mist). Because the remaining water in the base sink is not
below the lowest water level, it is a normal situation. We recommended rotating the power
knob to turn off the machine before lifting the water tank to avoid spraying atomized water on
the desktop.
1. Clean the water tank, water box, and atomizing plate once every two weeks. Make sure to
unplug the device before cleaning.
2. Due to the higher water hardness in some areas, the surface of atomizing plate is prone to
accumulate scale faster. Users should wash them regularly with detergent, and clean the
inside of the water tank and the water box every week under the following instruction: Place
5 drops of dish soap on the surface of the atomizing plate. Pour in approximately 30ml of
water. Use a dish brush or sponge to clean the atomizing plate, and water box until all lime-
scale is removed. Drain the dirty water and rinse the device twice.
3. Do not immerse the water box, water tank in hot water while cleaning.
4. There is an air inlet at the bottom of the machine. When cleaning, do not immerse the bottom
of the machine in water to avoid water entering into the machine from the air inlet and
damaging the machine.
5. External cleaning of humidifier: wipe the exterior surface with a soft wet cloth(the water
temperature should below 104°F.)
6. Do not use hard cleaning tools or chemical detergents when cleaning to avoid damaging the
parts.
7. Replace the water in the water tank on a regular basis to keep the product clean.
8. When the product is not in use for a long time, please pour out all the water and keep it dry.
Water Shortage
Maintenance
Note: There is a fan inside the air outlet. Make sure that the fan remains dry all the time.
Cleaning Brush
Atomizing Plate
Float Valve
Air Outlet
Air Outlet
Green Light:
Working status
Red Light:
Water tank is lifted or lack of water
