Eldom 5908277381790, Инструкция по эксплуатации, Страница: 6 / 16

ERROR MESSAGES ON THE DISPLAYER
TARE (setting zero)
The device enables the measurement and mixing of different components in one container (7).
In order to weigh each component separately, after putting and weighing the first component,
one should apply tare function by pushing the [ZERO] (1) button. The displayer (4) will zero a given
value and in its lower part, symbol “T” will be visible.
Now you can add another component. The weight or the volume of the latter is measured.
Similarly, other components of a given recipe should be dealt with.
Resignation from Tare Function
In order to complete the tare function (when the displayer (4) shows “0” and symbol “T”), you
should press the [ZERO] (1) button in order to restore the initial weight or volume (value before
application of the tare function). The symbol “T” will disappear from the displayer.
NOTE:
- mixing the components in the container (7) is easy and comfortable, however during the activity,
you should avoid pressing the bottom of the base as delicate assemblies were placed there.
Extensive power of pressure on the base may permanently damage the weight, changing the
results of the measurement
- temperature of the products weighed may not exceed 70 o C
Before pouring out the products from the container (7), it is recommended to take it off from the
base (6).
For that purpose, the blockade button (9) should be taken away.
LOW BATTERY INDICATOR (Lo)
– Necessity to replace the battery is signaled with the message “Lo”
REPLACING THE BATTERY:
1. Open the battery cover located on the bottom of the handle.
2. Remove the battery.
3. Insert a new battery (pay attention to the polarity)
4. Close the cover.
Dispose of the old batteries by putting them into special containers for batteries.
ERROR (Err)
– The device is overload. The weight of the product or the volume
in the pot exceeds maximum scope of the measurement.
FOT. 2
MEASUREMENT OF THE VOLUME
- switch on the device with single push of the button (1)
- wait until “0” appears on the displayer
- select one of the products indicated: water, milk, oil or flour,
by pushing the [MODE] (2) button a few times
- with the [UNIT] (3) button select the measurement unit. Depending on the selected type of the
product, there are the following measurement units available: grammas (g), milliliters (ml),
pounds-ounces (oz/floz) or cups (CUP)
- place the product in the container (7)
- read out the result of the measurement
The exactness of the indications on the displayer for pounds-ounces (lb-oz) and cups (CUP) is 1/8.
In order to obtain a wider scope and larger exactness, milliliters (ml) or grammas (g) should be
selected as the measurement unit and change again into pounds-ounces and cups, if need be.
NOTE: The measurement of volume is translated by the processor of the device on the basis of the
weight and density of a given component. On the market, there are different types of milk, oil,
sugar or flour available.
There may be certain deviations admitted in the measurement of volume depending on the type
of the product available. Thus, the value of volume indicated on the displayer of the pot may be
treated by orientation.
6