elddis Autoquest 100 2004, Руководство пользователя

Страница: 14 / 64

WATER
A Comet Elegance submersible water pump is
supplied with each motorhome. Connection to
the motorhome is made utilising either a
Carver Compact or a Carver Crystal 3 water
system. To determine which model you have,
please refer to the equipment chart contained
in your Owner’s Information Pack.
Ensure all taps are in the off position and the
12v water pump switch, located on the
electrical control panel, is off.
USING A WATER CONTAINER
(not supplied)
For either water system, fill fresh water
container and place in a suitable position.
Place waste water container under main drain
valve.
Place the submersible pump into the fresh
water container, ensuring it is fully submerged
before operating the system (see figure 3).
USING THE CARVER WATERLINE
(direct connection to mains supply unit)
This item is not supplied with every model.
Connect the Carver Waterline hose to the
mains unit on the pitch. (The end without the
valve connects to the mains unit).
CARVER CRYSTAL 3 WATER SYSTEM
OPERATION
Raise the crystal filter housing lid (see fig. 1).
Clean both the water socket and the power
supply terminals for the pump. It is advisable to
lubricate the water inlet using vegetable oil
(this reduces the friction between the ‘0’ ring
and the plastic surface).
Plug the pump assembly into the housing
ensuring that it is pushed fully home (see
fig. 2).
To remove the pump from the crystal housing,
press the two clips in at either side of the pump
plug and pull.
Do not remove by pulling the electric cable
or the hose.
CHANGING THE FILTER CARTRIDGE
When inserting a new filter cartridge into the
housing, smear vegetable oil on the two ‘0’
rings. (This reduces friction and makes it easier
to remove).
It is recommended that the filter cartridge is
replaced after 30 days of use.
To remove the filter cartridge pull the tab on the
bottom of the filter, which will release the filter
from the housing (see fig. 4).
10
CONNECTING SERVICES - WATER
Fig. 1 Fig. 2 Fig. 3