72964 0505 D/GB
nur Batterien vom Typ CR 2032
only batteries of type CR 2032
Fehlerbehebung Troubleshooting
•
Leuchten die LEDs nur noch schwach:
Wechseln Sie die Batterie.
•
Wenn die LEDs nicht leuchten:
Überprüfen Sie die Batteriepolung.
•
Reagiert das Gerät trotzdem nicht:
Verringern Sie den Abstand zur Funk-
steuerung oder lernen Sie den Kanal/die
Kanäle des Handsenders neu in die Funk-
steuerung(en) ein.
•
If the LED’s light up too faintly:
change the battery.
•
If the LED’s don't light up at all:
check that the battery is correctly poled.
•
If the device still doesn't react:
go closer to the radio control or re-transmit
the transmitter channel(s) to the radio control.
Kundendienst Customer service
Sollten trotz sachgerechter Handhabung Störun-
gen auftreten oder wurde das Gerät beschädigt,
wenden Sie sich bitte an folgende Adresse:
If, despite correct handling, faults or malfunctions
occur or if the product was damaged, please
contact the company at the address below:
ELDAT GmbH
Im Gewerbepark 14
15711 Zeesen
Deutschland Germany
Telefon Phone:
+ 49 (0) 33 75 / 90 37-0
Telefax Fax:
+ 49 (0) 33 75 / 90 37-90
Internet Internet: www.eldat.de
E-Mail E-mail:
Senden
•
Drücken Sie eine der Funktionstasten (AUF,
STOPP, ZU bzw. EIN, AUS), um das entspre-
chende Gerät anzusteuern. Die LED des zuge-
hörigen Kanals leuchtet kurz auf (3).
Nur RT24-5004E: Bei ausgewählter Gruppen-
funktion werden alle 4 Geräte angesteuert, und
es leuchten alle 4 LEDs gleichzeitig kurz auf.
Batterie wechseln
•
Stecken Sie eine kleine Münze in die Kerbe auf
der Unterseite des Senders. Drehen Sie die
Münze diagonal und drücken Sie die Gehäuse-
teile vorsichtig auseinander.
•
Wechseln Sie die Batterie (4).
Achten Sie auf die richtige Polung!
•
Drücken Sie die beiden Gehäuseteile wieder
zusammen.
Achtung! Bewahren Sie die Batterien außerhalb
der Reichweite von Kindern auf!
Allgemeine Informationen
Entsorgungshinweise
Altgeräte und Batterien dürfen nicht mit dem
Hausmüll entsorgt werden!
Entsorgen Sie das Altgerät über eine
Sammelstelle für Elektronikschrott oder
über Ihren Fachhändler.
Entsorgen Sie die Altbatterien in einen
Wertstoffbehälter für Altbatterien oder
über den Fachhandel.
Entsorgen Sie das Verpackungsmateri-
al in die Sammelbehälter für Pappe,
Papier und Kunststoffe.
Gewährleistung
Innerhalb der gesetzlichen Garantiezeit beseitigen
wir unentgeltlich Mängel des Gerätes, die auf
Material- oder Herstellungsfehler beruhen, durch
Reparatur oder Umtausch.
Die Garantie erlischt bei Fremdeingriff.
Konformität
Dieses Produkt erfüllt die wesentlichen
Anforderungen der R&TTE-Richtlinie
1999/5/EG.
Für den Einsatz in: EU/CH/FL/IS/N
Die Konformitätserklärung ist auf folgender Inter-
netseite abrufbar: www.eldat.de.
Technische Daten
Spannungsvers.:
1x 3-V-Batterie, CR 2032
Stromaufnahme:
ca. 10 mA
Frequenz:
868,30 MHz
Modulation:
FSK
Betriebstemperatur:
-20°C bis +60°C
Reichweite:
im Freien: ca. 100 m
im Gebäude: ca. 30 m
Abmessungen:
110 x 38 x 14 mm
(ohne Wandhalter)
Gewicht:
37 g (inklusive Batterie,
ohne Wandhalter)
Transmission
•
Press one of the function buttons (OPEN,
STOP, CLOSE or ON, OFF) in order to control
the corresponding device. The LED of the cor-
responding channel briefly lights up (3).
Only RT24-5004E: If the group function is se-
lected, all 4 devices are controlled and all 4
LED’s briefly light up at the same time.
Replacing the Battery
•
Insert a small coin into the slot on the bottom
side of the transmitter. Turn the coin diagonally
and carefully press the two halves of the hous-
ing apart.
•
Replace the battery (4).
Make sure the polarity is correct!
•
Press the two housing halves together again.
Caution! Keep batteries out of reach of children!
General Information
Disposal
Waste electrical products and batteries should
not be disposed of with household waste!
Dispose of the waste product via a
collection point for electronic scrap or
via your specialist dealer.
Dispose of used batteries in a recycling
bin for batteries or via the specialist
trade.
Put the packaging material into the
recycling bins for cardboard, paper and
plastics.
Warranty
Within the statutory warranty period we undertake
to rectify free of charge by repair or replacement
any product defects arising from material or produc-
tion faults.
Any unauthorized tampering with, or modifications
to, the product shall render this warranty null and
void.
Conformity
This product conforms to the basic
requirements of the R&TTE Directive
1999/5/EC.
For use in: EU/CH/FL/IS/N
The Declaration of Conformity can be found on the
Internet at: www.eldat.de.
Technical Data
Power supply:
1x 3V Battery, CR 2032
Current consumption: approx. 10 mA
Frequency:
868.30 MHz
Modulation:
FSK
Operating temperature -20°C to +60°C
Range:
free-field: approx. 100 m
buildings: approx. 30 m
Dimensions:
110 x 38 x 14 mm
(without mounting plate)
Weight:
37 g (incl. battery,
without mounting plate)
3
4