R
20
PROBE:
Only for dual function probes (FNF and F1
2). Changes probe mode.
FNF probes - select from Automatic, F or N.
F1 2 probes - select from F1 or F2.
UNITS:
Units are automatically set by the probe
type, however the user can manually override the
automatic setting. Select from µm, mm, mil, thou or
inch.
AUTO SWITCH OFF:
Changes delay before
gauge switches off when displaying Reading
Screen.
•
Minimum = 1 minute
•
Maximum = 10 minutes
•
Default = 1 minute
Auto switch off may be disabled by selecting ‘off’ (In
this case, switch off using On/Off key
.)
OUTPUT:
Activates data output. Toggle tick box to
activate/deactivate. When activated, readings are
sent to the mini portable printer as they are taken.
See “Miniprinter” on page 42 for sales part number
of this optional accessory.
OUTPUT:
Selects baud rate (Figure 18) and
activates data output via the RS232 interface - see
“Interfaces” on page 12.
Figure 18. OUTPUT screen
BAUD RATE
can be set at values from 1200 to
19200. The default value is 9600 baud.
RS232 BIT IMAGE
Toggle
tick
box
to
activate/deactivate. When activated, readings are
sent to the RS232 interface as they are taken. All
images and characters are output as bit-maps. This
allows printing on the Elcometer Miniprinter (see
“Miniprinter” on page 42).
RS232 PLAIN TEXT
Toggle tick box to
activate/deactivate. When activated, readings are
sent to the RS232 interface as they are taken. The
gauge sends standard ASCII characters from the
Courier New font set
d
. This allows printing on
devices other than the Elcometer Miniprinter, e.g.
Op_456_3_English.book Page 20 Thursday, January 22, 2009 7:58 PM
