uSing the device
remote control
Note: Remote control should be pointed so that its front end (IR LED) aimed towards the remote control sensor on
Uniq Display. The controls are sufficiently sensitive to the captured commands reflected from the walls and
surrounding objects.
Use supplied remote control to control the Uniq Display. Its functions are described in the following figure.
uniq Display remote control
Figure 2.1.
turning on
and off
unused buttons
entering the menu and
menu navigation
changing settings,
menu item selection
selecting source
of the videosignal
(unused)
programmable button
(by default brightness
mode changing)
turning on and off
Note: Before connecting or disconnecting cables we recommend to shut down the computer and Uniq Display.
Connect the VGA cable to Uniq Display and the other end to your computer. Connect the power adapter to
the Uniq Display and plug the other end into an electrical outlet. If Uniq Display detects the VGA signal on
its VGA input, it turns on automatically (this behavior can be changed in the Uniq Display menu). If this is
not the case, the Uniq Display is turned on and off the by pointing the remote control at the remote sensor
and pressing the POWER button on the remote control. It takes about 3 seconds from pressing the button
until the image is displayed. If a source of the video signal is not connected to the Uniq Display, it will show
the message “No signal input” when turned on.
22
Using the device
&/(-*4)