2
To scan bar codes:
1. Aim the scanner at a slight angle or pitch to the bar code and press the trigger.
2. If you did not get a good read, adjust the scanner distance from the bar code and the
position of the scan beam to make sure you scan every bar and space. The optimum
reading stance between scanner and barcode is 15-20 cm.
3. On a successful read, there’ll be a beep sound, beam dies out. The scanner then
transmits barcode message to the Host.
4. To instantly upload data, please make sure that the terminal is in range and
associated to the base, or program will automatically turn into storage mode. The
terminal communicates with the base at long distance of 150 meters indoor or 300
meters outdoor.
Configuring the scanner:
Play around in the settings menu to configure the device to your exact specifications.
Setting Code
Description
Note
Normal Mode
(instant upload mode)
Scan this code to enter
normal scanning mode.
Under this mode, data will
be transmitted to the base
upon scan.
(defaulted)
The scanner emits 1 beep and
the blue light flashes once when
the base successfully receives
signals.
The scanner emits 3 beep and
the blue indicator flashes 3 times
when the base is not successfully
associated with scanner. The
scan result will be automatically
stored in the scanner.
Storage mode will be activated
to replace normal mode when
the base fails 3 times in a row
receiving a signal.
Storage Mode
Scan this code to enter
Storage mode.
Under this mode, scans will
be stored in the scanner.
Under this mode, the red light
is on. The blue light will flash
when a code is successfully
read and stored.
Upload data
Scan this code to uploading
stored data.
All data in the scanner will be
uploaded to the corresponding
base.
(Note: if the data of previous
operations are not cleared but
still stored in the scanner, they
will also be uploaded.)
You can scan this code to
re-upload all stored data when
uploading is stopped due to
improper base association.
(During uploading, the scanner
responds as under normal
mode)
Upload data of last
operation
Scanner this code to upload
data of the last operation
(from the last startup) to the
base.
