ELC DLN8GBX, Руководство пользователя

Страница: 6 / 13

__________________________________________________________________________________
ELC dmXLAN nodeGBx 8 User Manual
DMX port as input
When a port is set up as a DMX input it can operate in the following modes;
•
Disabled

the DMX input does nothing
•
Normal

any valid DMX is sent onto the network (and internal use) using
the selected universe (Art-Net)
o
LED indicator setting: fixed color / universe color / DMX RGB
o
Universe: Art-Net / sACN / ShowNet
•
Backup

the DMX input will not send data if the selected universe is
present on the network. If the selected universe is not present on the network for
several seconds and the input has valid DMX, then it will send DMX data.
If another sender starts sending the same universe, the input will go back into
backup mode.
o
LED indicator setting: fixed color / universe color / DMX RGB
o
Universe: Art-Net / sACN / ShowNet
DMX port as output
When a port is set up as a DMX output it can operate in the following modes;
•
Disabled

the DMX output is disabled
•
Out Zero

the DMX sends out a DMX test signal with all channels at 0%
•
Single

the output sends out the DMX values of the selected (primary)
Art-Net universe. The DMX output is enabled the first time it detects the DMX
universe on the network (or internal DMX inputs). If the universe on the network
fails, the DMX output will go into DMX hold.
•
HTP

highest takes precedence
•
Priority

as long as the primary universe is active, it will be on the output –
otherwise the secondary universe is sent on the output
•
Flexpatch

setting used when programmed via dmXLAN software
The primary, secondary and tertiary universes can be set to either Art-Net, sACN or
ShowNet.
The Resend option can be used to send the merged signal onto the network again as a
new universe. This is helpful when
– for example – 3 universes need to be merged
together.