REBLE610 Fully indoor Microwave Link
Page 34 of 52
Version 1.4
8.3.1
Controller
–
Coil fans.
Figure 57: Web controller form – fans.
This frame let drive and monitor the functionality of front panel fans.
Checkbox
Manual
set in manual mode the configuration of the fans speed, measurable in Speed box in
rpm. In this case, it is necessary to manually set the speed.
In case checkbox
Manual
is disabled, on the contrary, it is required to establish temperature targets for
modules equipped with sensor, and the system controller will program fan controller so as to keep modules
at temperature set by the user.
Right fan is managed according to transmitter board temperature (if installed, so not available in half
duplex receiver configuration); left fan according to temperatures detected on modem and receiver boards.
Modifications are validated pushing
Apply
button.
Table 16: Fan management.
Manual
Checkbox fan manual management.
Speed(rpm)
Only available in manual modality, shows the right fan
speed in rpm.
Temperature target Target temperature for transmitter board (available in
automatic modality).
Rx
Temperature
target
Target temperature for receiver board (available in
automatic modality and only for models with receiver).
Modem
Temperature
target
Target temperature for modem board (available in automatic
modality).
8.3.2
Controller
–
Customer.
Figure 58: Web Controller form – Customer info.
