Elba Smart Drive, Инструкция по установке и руководство пользователя

Страница: 27 / 32

25
Operating problems
Pressing
POWER
does not turn the machine on.
Is the power switched on at the wall?
Switch the power off at the wall and wait 60 seconds before turning the power on again.
Could your household power supply be at fault? Try plugging in another electrical appliance.
Pressing
START/PAUSE
does not start the fill.
Are both hot and cold taps turned on?
Are the inlet hose filters blocked?
Filling continuously.
Check that the machine is not syphoning (refer to page 3 in the ‘Installation Instructions’).
Not spinning properly.
Is the load out of balance? (refer pages 11,13 and 20).
Check the machine is level and does not rock (refer page 4).
It may have suds build-up (refer to rinse light or spin light flashing, page 23).
Spin speed sounds slower than it should.
The clothes are unevenly distributed in the bowl, your washer has compensated by lowering
the spin speed.
Machine is continually going out of balance.
Check the machine is level and does not rock (refer to page 4).
Too much water for load (refer to page 11).
Noises.
Banging – load is out of balance (refer pages 11, 13 and 20).
Other noises – refer page 22.
Small puddle of water coming from under the machine.
The water level is too high for the amount of clothes. This has caused excessive splashing. Use
a lower water level. (Refer to page 11).
Large bulky, garments (eg pillows, duvets) can cause splashing. Wash on
DELICATE
cycle (refer
to page 13).
If the problem persists contact your Fisher & Paykel Dealer or Authorised Service Centre (refer to
page 28).