Elba EGH-A9241GX, Руководство пользователя, Страница: 12 / 17

ELECTRICAL CONNECTION
The appliance is profited to operate with a
power supply voltage of 230Vsingle-phase. The
connection must be made in accordance with
the regulations and laws in force.
Before making the connection, make sure that:
1) the safety circuit-breaker and the electrical
system are able to withstand the load of the
appliance(see nameplate).
2) The power supply system has an earth
connection in good working order in
accordance with the regulations in force;
3) The socket or omni polar switch use are
easily accessible with the appliance
installed.
Fit a plug suitable for the load on the power lead
and connect it to a suitable safety socket.
If you wish to make a direct connection to the mains, an omni polar switch with
a gap between the contacts of at least 3 mm, of suitable rating for the load and
complying with the regulations in force, must be installed between the
appliance and the mains. The switch must not break a contact in the
yellow/green earth wire.
The brown live wire (connected to the “L” terminal of the terminal board) must
always be connected to the live wire of the power supply mains.
In all cases, the power supply lead must be positioned so that it does not
reach a temperature 50
o
C above the room temperature at any point.
One example of an ideal route is shown in the illustration. The cable is guided
by means of band clamps fixed to the side of the cabinet, in order to avoid any
contact with the appliance underneath the hob.
REPLACING THE POWER SUPPLY LEAD
If the lead has to be replaced, only HO5RR-F or
HO5RN-F type cables suitable for the load and the
operating temperature must be used. In addition, the
yellow/green earth wire must be about 2 cm longer
than the live and neutral wires.
11