Elation SHOW DESIGNER 1, Руководство пользователя

Страница: 26 / 50

w w w . e l a t i o n l i g h t i n g . c o m
26
SHOW DESIGNER 1™ User Manual
P R E S E T S [ c o n t i n u e d ]
RECORDING PRESETS
Before recording a preset you must first do some preparation. In order to be able to
view certain channels like color or gobo you will first need to raise dimmer levels
and move the pan or tilt positions in order to see the color or gobo selection. Do this
by selecting the fixture or fixtures to be used in the preset and then position the
beams and turn up the dimmer levels. These things will not be recorded into the
preset if they are done before pressing record.
To start recording a preset press “record”, its LED will flash. Next press “PRESET”, and
this LED will also flash. The page display will show the current page and any number
locations that already contain presets will be lit. Adjust the channel or channels
that you want to include in the preset. These adjustments will be recorded so take
care not to change any channels that you don’t want included in the preset.
Note: When recalling a preset, if some channels are affected that weren’t intended
to be part of the preset, chances are that a fader or the joystick was bumped while
recording and those channels were accidentally added. If this happens, go back
and rerecord the preset.
While recording a preset you can turn a fixture on or off by pressing the “FIXTURE”
switch. Use the number switches to toggle any fixtures on or off. Pressing “FIXTURE” a
second time will turn off the fixture LED allowing you to finish recording the preset.
At any time while recording the preset you can enter a name for the preset. Use
the cursor switches to move the cursor in the display under each character then
use the + or - switch or the data wheel to select characters.
To save the preset, select the page and number where you want it saved. If you
select a number that is already lit, a message will appear asking if you want to write
over the existing preset. Press “YES” or “NO”. You can use the page switches to
select from pages 1 to 32, which will let you store up to 512 presets. You cannot
record over or edit the factory presets on pages F1 or F2.
NOTE: It can take several seconds to overwrite or erase a preset depending on how
much memory is currently in use.
After saving a preset, the record LED stays lit allowing you to continue to record
more presets. Any channel changes that were made previously will still be included
in any new presets. To start a new preset from scratch, toggle the “PRESET” LED off
and then back on while the “RECORD” LED is still flashing. This will clear out the edit
buffer. To exit record mode, press “RECORD”, all LEDs will stop flashing.