Elation POWER SPOT 700CMY II, Руководство пользователя

Страница: 24 / 72

Power Spot 700CMY II™
©Elation Professional, Los Angeles Ca. 24 www.ElationLighting.com
CL1f Fine calibration of color wheel 1 (CTO)
GOB1 Calibration of gobo wheel 1
GOB2 Calibration of gobo wheel 2
SHSH
Shutter moves pair wise open and close
SHOC Shutter moves pair wise parallel left and right
FR-B Calibration of frost filter A
FR-T Calibration of frost filter B
PRSO Calibration of prism disengaged (home) position
PRSI Calibration of prism wheel engaged (on) position
IRIS Calibration of iris
FOCU Calibration of focus
POFS
Calibration of Pan-Offsets
TOFS Calibration of Tilt-Offsets
CLRE Settings in the internal memory (super-user only)
SPFS Speed fast - limit the max. Pan velocity to 70%
DFSE Resets the fixture to the factory default settings values
CGSW Color/Gobo Short Way – On/Off
FEED
Pan/Tilt feedback (error correction) On/Off
EFLG Correction of faults

D
O
W
N
-
U
P

8.1 Setting/Changing the DMX Address
After applying power to the POWER SPOT 700CMY II™ the LED will display the
fixture’s current DMX address immediately after the reset sequence. If the fixture is
not receiving a DMX signal the display will flash continuously.
D001
To set or adjust a DMX address, please follow the procedure below:
1. Switch on the POWER SPOT 700CMY II™ and wait for the fixture reset process
to finished ( 'RST' will flash in the LED while fixture is in reset mode).
2. Press the Mode button to access the main menu. Toggle through the menu by
pressing the Up and Down buttons until the display shows D001. Tap the enter
button to make changes to the address. When the address is ready to be
changed four dots in between the current address will begin flashing.
3. While the dots are flashing, use the Up and Down buttons to select adjust the
address. Lock your new address into the unit’s memory by pressing the Enter
button. After the new address has been successfully stored into the fixture’s
memory the LED will briefly readout
OK .