5
5.
Channel Selector:
Moving to the left gets channel 1-4 output, moving to the right gets channel 5-8
output.
3 Operation Guide
3.1
Channel output and controlling functions
3.1.1 8 channels / 16 channels output control:
•
8 channels output and 16 channels output are available for the user’s application.
•
Switch the CH1-8/CH1-16 selector to “CH1-8” position, then 8-channel output function will
be available.
•
Switch the CH1-8/CH1-16 selector to “CH1-16” position, then 16-channel output function will
be available.
3.1.2 EFFECT / LATCH / FLASH function:
•
Turn
on the EFFECT Switch under 8 channels output mode, relevant channel output will run
normally.
•
Turn off the EFFECT Switch under 8 channels output mode, relevant channel output will be
disabled.
•
Press relevant Channel button to lock (LATCH) or trigger (FLASH) the corresponding
channel output. Relevant Channel button function (LATCH or FLASH) is controlled by the
FLASH / LATCH selector.
•
When in 16-CH mode, EFFECT Switch can function as well as in the 8-CH mode. On the
other hand, EFFECT Switch can control two relevant channel outputs at the same time.
For example, the EFFECT switch which controls channel 1 can simultaneously control
channel 9 under 16-CH mode. The function of each Channel button will be controlled by the
FLASH / LATCH selector: switch to “LATCH” position for LATCH function, and switch to
“FLASH” position for FLASH function.
3.1.3 Chase speed control:
Relevant Chase speed can be controlled by:
a. the audio signals.
b. SPEED adjuster under
×
1 mode.
c. SPEED adjuster under 10 min. mode.
•
Switch the “Chase mode selector” to AUDIO mode, then the Chase speed will go sensitively
following the audio signals. Audio sensitivity can also be controlled by the Audio adjuster —
you can
get higher levels while adjusting towards “Max”, and get lower levels towards “Min”.
•
Switch the “Chase mode selector” to
×
1 mode, then the Chase speed will be controlled by
the relative SPEED adjuster, the fastest Chase speed can be within a few seconds.
•
Switch the “Chase mode selector” to the 10min mode, then the Chase speed will be
controlled by the
relative SPEED adjuster, the slowest Chase speed can come to the level of
10 minutes.
3.1.4 MANUAL / AUTO Mode
•
Switch MANUAL/AUTO selector to MANUAL mode, you can then select anyone of the
built-in Chasing
programs by pressing the Mode button manually. Each tap will change the
program once.
•
Switch MANUAL/AUTO selector to AUTO mode, then all the 16 built-in Chasing programs
will
run circularly and automatically.
3.1.5 Enable / disable signal output for Switch Pack
