Elastix ELX-3000, Инструкция по сборке

Страница: 14 / 14

VII. PACKAGING
1. Before turning off the ELX-3000 to begin packing it, run the following console command:
history -c
2. Press the ELX-3000’s Power button and wait for the shutdown process to complete
3. Disconnect and tidily tie the power cord
4. Disconnect the data and power cables of the SATA CD or DVD drive from the motherboard (skip this step if you
installed Elastix from an external optical drive instead)
5. If instead an external optical drive was used for the installation ( not recommended ), disconnect it from the
corresponding port on the back of the ELX-3000
6. Place the warranty seals on the telephony cards inside the appliance (if applicable)
7. Place and screw both covers to the top of the case
8. Place the warranty seals on all three outside edges on the case’s top cover (the cover with the Elastix logo)
9. Generate and place the label with the Serial Number on the right side of the case (when the power button is
facing you)
10. Wrap the ELX-3000 inside the plastic bag
11. Place the two pieces of sponge on the case’s lateral ends
12. Place the appliance, with the sponges on its sides, inside the box
13. Ensure that the following parts and documents are properly placed inside the ELX-3000’s box:

Power cord (either American or European model depending on the region it will operate in)

Two rack-mounting ears and 6 screws for attaching them to the case

A (flexible) dual PCI riser (RS-1U2 type B)

Two mounting ears to fix PCI cards inside the ELX-3000 and 2 screw to attach them properly

“Please Read First” sheet

Service Letter

Invoice / Delivery Note

Original telephony PCI card’s box (if applicable)
14. Close the box and secure it with packing tape