Elastic Networks 401, Руководство по установке

Страница: 19 / 32

Installing the StormPort 401 eSled Modem 1-19
Revision 1.0 Storm Port 401 eSled Modem Installation Guide
08-00025-01
Task:
Installing the Wall Mount Filter
Follow these instructions precisely to install the Wall Mount Filter. If the
telephone filter is installed incorrectly (reversed), the filter will not allow voice
signals to pass. (See Figure 1-2, Wall Mount Filter Installation.)
Step Action
1 Check for a dial tone.
2 Remove the telephone from its wall mount by pushing it upward and pulling
it away from the mounting pins. The telephone may have a short “pig tail” line
cord connecting it to the jack. If the phone has a “pig tail” line cord, disconnect
it from the wall jack.
3 Plug the filter’s short “pig tail” line cord into the wall jack.
4 Install the wall mount filter by placing it over the wall jack and sliding it
downward until it is seated on the mounting pins.
5 Plug the telephone “pig tail” line cord into the jack located on the front of the
filter.
6 Install the telephone on wall mount filter.
7 Verify that there is a dial tone. If a dial tone is not present, check all
connections.
Figure 1-2. Wall Mount Filter Installation