Elan EL-IPD-AMP-2CH, Быстрый старт

Страница: 9 / 12

9
QUICK START GUIDE EL-IPD-AMP-2CH
Installation
Mount the EL-IPD-AMP-2CH 2 Channel Audio Amplifier in a cabinet by setting it on a sturdy shelf. As with any electronic
device the EL-IPD-AMP-2CH generates heat at all times, but considerably more when in use. Ensure clear positive airflow
within the cabinet by using fans. Locating the EL-IPD-AMP-2CH in a completely enclosed cabinet is not recommended
due to heat build up. Use the included mounting brackets to secure to a wall or other surface if needed.
POWER
The amplifier includes an internal switch mode power supply for use in AC 100-120 / 220-240 V environments.
NETWORK
Connect the amplifier to the LAN for control and audio routing (if used in a Dante configuration). Please review the ELAN IP
Amp Design Guide for proper network setup depending on how the amplifier is being used.
AUDIO INPUTS
Two 2 channel PCM digital inputs (1 optical and 1 coax stereo) 2, and one line level analog stereo pair audio inputs are
available. When used with other Dante-enabled ELAN amplifiers, the input device is available as an independent source
available to any zone in the system.
NOTE: The amplifier is limited to one input device at a time. The input (Analog, Coax, or Optical) is selected using ELAN
Configurator during installation.
Subwoofer Out
Connect a powered subwoofer.
SPEAKER OUTPUTS
CAUTION! ALL SPEAKER WIRE CONNECTIONS MUST BE MADE WITH THE CHASSIS POWER OFF
When connecting more than one speaker to a set of terminals, be sure to calculate the impedance values and not exceed
the rating for the amplifier.
Connect 4ohm or 8ohm speakers - The amplifier outputs' default is 4ohms. If connecting 8ohm speakers, the setting must
be changed during system configuration. For more detail, see the Design Guide for the ELAN IP Amplifier.
CONFIGURATION
For detailed configuration information, download the Design Guide for the ELAN IP Amplifier from www.elanhomesystems.com.
MAC ID
Serial No.
ANALOG IN
L R
EL-IPD-AMP-2CH
- L +
BRIDGE
Stereo Mode 4-8Ω
Bridge Mode (Mono) 8Ω
Speaker Outputs Class 2 Wiring
- R +
SPEAKERS SUB OUT
COAX
IN
OPTICAL
IN
ETHERNET
CAUTION: REPLACE
WITH SAME TYPE
T3.15AL 250V FUSE
RESET
100–240 V~, 50/60 Hz
200
W
A
TTS