Amplifier GUI Control Panel
MULTI-CHANNEL POWER AMPLIFIER | www.elac.com | Page 10
Accessing amplifier GUI Control Panel
Open a Web browser.
In the Web browser address bar type in the IP address of the amplifier and hit enter.
GUI Controls Defined
The amplifier GUI control panel Home page is shown in Figure 6.
Most of the GUI controls are self explanatory, but some of the controls are described in
detail, below.
Power - Use this control to turn On/Off the amplifier.
Power Mode - Use this control to select the power ON/OF mode of the amplifier:
• Auto On/Off - The amplifier is detecting the audio signal and it is turning on/off
automatically. If there is no audio for aprox. 20 min. the amplifier is turning Off.
• Audio Detect Level - Alows you to select the sensitivity (in mV) of the Auto On/Off mode.
• 12V Trigger - Requires 12V (5 ... 24V DC) control connected to the amplifier. In this mode
the On/Off commands from Ethernet will not work.
• Ethernet - Use this mode for home automatization audio system.
• Always On - In this mode the amplifier never turns Off.
Reset - There are two reset modes:
• System - Use this reset mode to restart the amplifier without the need to cycling the
power.
• Factory - In this reset mode you can reset he amplifier all the settings, except the IP
settings. The IP settings reset can be done only from the RESET button at the rear panel of
the amplifier.
Save/Load - Use these controls to save and load a configuration of the amplifier.
• Save - Use this control to save your amplifier configuration settings.
• Load - Use this control to load the amplifier configuration settings from a saved file.
Firmware Update - Allows you to update the amplifier firmware. Firmware update will also
restart the amplifier.
Password - Use these fields to enter the amplifier password.
Ethernet - These fields are used to set up the IP settings for the amplifier.
