8
EN
INTRODUCTION
Please read the instructions before use and keep them safe for future reference.
SAFETY
- Make sure the voltage of the power outlet matches the voltage of the product.
- Always uncoil the LED strip completely before connecting to the power outlet.
- Never use the LED strip while it is coiled on the reel. This could result in overheating.
- Do not use the LED strip if it is damaged. Always check the LED strip before use.
- Avoid bending the LED strip sharply, as this could damage it. Bend radius d> 50 Ø mm.
- If the power cord or LED strip is damaged you should discard the product or repair it using the repair
kit.
- This product is not intended for use by children or people with physical disabilities, reduced sensory
or mental capacity, or who lack experience and knowledge of its use, unless they have already been
instructed by a person who is responsible for their safety.
- Do not connect LED strips together in lengths greater than 100 m.
- Make sure there is good air circulation around the LED strip.
APPLICATION AREA
- Carefully uncoil the LED strip from the reel. There is no need to remove the plastic film; this protects
the LED strip from overpainting, etc.
- Install the LED strip according to the installation instructions.
- Connect to a suitable power outlet.
- When work is finished, disconnect the product from the power outlet or turn off the power.
- When needed, clean the LED strip and power cord with a dry or damp cloth.. Never use chemicals.
- Adjusting the length: If needed, the LED strip can be cut at 20 cm intervals, where the scissor symbol
is visible on the LED strip. The end of the LED strip should then be sealed with an end cap from the
“FLEX LED strip – Repair kit”. NOTE: Disconnect the LED strip from the electrical supply before
cutting the strip.
NOTE! The product must not be connected to the power outlet while it is being installed or coiled on
USE
Max. bend radius
The LED strip is completely sealed and designed for many applications. It can be installed in many
different ways and works equally well horizontally or vertically. It is important that the housing of the
LED strip is intact before it is installed.
