- 14 -
STEP 2
Insert two (2) O-rings (14 x 1 mm) into slots on the cold plate. Then
carefully place the active backplate on standoffs as shown in the
image. While putting the active backplate on the PCB, make sure
the O-rings stay in the slots.
Before attaching the Active Backplate, make sure all the
Thermal Pads are placed correctly!
STEP 2
ACTIVE BACKPLATE
OR 14 x 1
EPDM 50
STEP 3
Place six (6) M3 x 10 AX1 screws into the water block standoffs
and tighten them using a Philips head screwdriver (as shown in the
image). After attaching the AX1 Screws, three (3) terminal screws
M4 x 20 DIN7984 need to be attached using Allen Key 2.5 mm. The
terminal badge can be reused, after securing the terminal screws.
STEP 3
M3 x 10 AX1 SCREW
Allen Key 2.5mm
For this step, you will need:
Phillips Head Screwdriver
M4 x 20 DIN7984
SCREW
TERMINAL
BADGE
