- 13 -
To ensure the installation of EK components was successful, we
recommend you perform a 24-hour leak test.
When your loop is complete and filled with coolant, connect the pump
to a PSU outside your system. Do not connect power to any of the other
components. Turn on the PSU and let the pump run continuously.
Inspect all parts of the loop, and in case the coolant leaks, fix
the issue and repeat the testing process. To prevent possible
damage, please ensure that all hardware is dry before the system
is powered on.
TESTING THE LOOP
REPLACING THE LED STRIP (Optional)
STEP 1
If you want to replace the D-RGB LED strip, you must remove the two
(2) standoffs shown in the picture using a 6mm wrench. Remove the
stickout and replace the LED strip.
Once you have replaced the LED strip, align the holes on
the stickout with holes on the top plate, and tighten the
standoffs evenly.
STEP 1
