- 8 -
Do not forget install the Backplate Insulator and Backplate
(as shown on the photo). They should be oriented to
match the holes.
ATTACHING BLOCK ON THE MOTHERBOARD
STEP 1
Prior to fastening the screws please make sure the mounting holes
on the
motherboard’s
circuit board are aligned with the water block.
Mosfet part:
Use four (4) M2.5 x 5 AX1 Screws with PVC washers.
Tighten the screws evenly. Do not use excessive force when
tightening the screws.
CPU part:
Use four (4) M4 x 12 DIN 7984 with screws. Tighten the
screws using enclosed 2mm Allen Key.
STEP 2
For the MSI Z690 Carbon EK X series water block to operate properly
the bottom G1/4 port of the water block
MUST BE USED AS THE
INLET PORT
.
EK recommends the use of EK-Fittings. When using fittings other
than EK series please use hose clamps or appropriate substitute
to secure the tubing to the barb. The use of biocide containing and
corrosion inhibiting coolant is always recommended for any liquid
cooling system.
PVC WASHER
M2.5x5 AX1 SCREW
M4x12 DIN7984
LGA 1700
BACKPLATE
BACKPLATE
INSULATOR
STEP 1
IMPORTANT:
USE THIS OPENING
AS AN INLET PORT!
STEP 2
