All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use.
Revision 1.0. Published on August 27
th
2019
3. PLACING THERMAL PADS ON MOTHERBOARD
.
Place thermal pads on PCB as shown on the picture below.
STEP 3: PLACING THE BLOCK ON TO MOTHERBOARD
Place the EK-Momentum Z390 MEG Godlike Monoblock series water block gently
to the motherboard or vice versa (as shown on photo below). Make sure that
mounting holes are aligned
. There is no need for M2.5 adhesive PVC washer on
MSI Z390 MEG GODLIKE motherboard.
Plug the 3-
pin connector from Water block’s D
-RGB LED light to the D-RGB HEADER on
the motherboard. The LED will work if the pin layout on the header is as follows:
+5V digital, empty, Ground.
Please ensure that the arrow indicated on the connector is plugged into the
+5V line as indicated on your motherboard.
STEP 4: ATTACHING BLOCK ON TO THE MOTHERBOARD
Prior to fastening the screws please make sure the mounting holes on the
motherboard’s circuit board
are aligned with the water block.
A)
Mosfet part:
Use four (4) M2,5x5 AX1 screws with M2.5(0.5mm) PVC
washers. Tighten the screws evenly. Do not use excessive force when tightening
the screws!
B)
CPU part:
Use four (4) M4x8 DIN7984 screws and M4(0.8mm) washers.
Tighten the screws using enclosed 2.5mm Allen key.
Use the enclosed screws and washers as shown in picture below:
For the EK-Momentum MSI Z390 MEG Godlike Monoblock series water block to operate
properly the G1/4 port nearest to the right edge of the water block
MUST BE USED
AS THE INLET PORT
. EK recommends the use of EK- Fittings. When using fittings
other than EK series please use hose clamps or appropriate substitute to secure the
tubing to the barb. The use of biocide containing and corrosion inhibiting coolant is
always recommended for any liquid cooling
system
.
REQUIRED TOOLS AND MOUNTING SCREWS:
Scissors
Philips screwdriver
Allen key
IMPORTANT: USE
THIS OPENING
AS AN INLET
PORT!
Plastic washer M4 0.8mm
M4X8 DIN7984 Screw
M2.5X5 AX1 Screw
PLEASE REMOVE THE
PROTECTIVE FOIL FROM BOTH
SIDES OF THE THERMAL PADS
PRIOR TO INSTALLATION!
Thermal Pad F.1.0mm
