All disclosures, notices and warranty conditions are being written on the EKWB website. Please read terms of use. Released on 5
th
of April, 2018; Revision 2.0
STEP 5: INSERTING THE CARD IN YOUR PC CASE
Carefully lift your graphics card with installed block and insert it in your PC’s motherboard PCI
-express expansion slot. Please bear in mind that your graphics card is probably
heavier than when it was equipped with original heat sink fan assembly. One needs to be very careful when handling the graphics card. Avoid all un-needed manipulation of the
VGA/water block assembly that might damage your card or water block during final installation.
STEP 6: CONNECTING THE RGB LED STRIP
Another option is to connect RGB_HEADER to the graphic card. If you choose this option, make sure to connect RGB_HEADER before you install water block to the graphic card
(before step 2). Align RGB connector and RGB cable along with the groove (see pictures below). The LED will work if the pin layout on the header is as follows:
+12V G R B
.
Please ensure that the triangle indicated on the connector is plugged into the +12V line as indicated on your graphic card.
Failure to do so will damage your graphic card or LED strip.
REQUIRED TOOLS:
scissors
Philips head screwdriver
Plug the 4-
pin connector from Water block’s RGB LED
light to the RGB_HEADER on the motherboard. The
LED will work if the pin layout on the header is as
follows:
+12V G R B
.
Please ensure that the arrow indicated on
the connector is plugged into the +12V line
as indicated on your motherboard.
Failure to do so will damage your motherboard or LED
strip.
RGB LED Connector