7. ATTACHING WATERBLOCK TO MOTHERBOARD. Place waterblock over motherboard and insert mounting elements in order as shown. Gently screw in all screws and make
sure waterblock is attached.
STEP 3: CHECKING FOR CONTACTS
Temporarily remove the water blocks to check for uniform surface contact between the block and the components. Note the pattern of contact on a piece of paper. Then repeat
steps 5 and 7 to reattach the block applying more or less pressure to the areas where you have found it necessary.
STEP 4: POSITIONING FITTINGS AND CONNECTING TO WATER CIRCUIT
Screw in fittings, attach the liquid cooling tubes and connect the water-block(s) into the cooling circuit. The EK-FB ASUS X58 series are not sold with high flow fittings. To ensure
that the tubes are securely attached to the barb fittings, please use hose clamps or an appropriate substitute. The use of an algaecide is always recommended for any liquid
cooling system.
You can use any hole as an inlet/outlet hole.
On sample picture you can see complete water cooling solution by EKWB. Please note that mosfet blocks are not included. Please visit our website and cooling configurator for
further product information and compatibility results.
REQUIRED TOOLS AND MOUNTING SCREWS:
scissors
philips screwdriver
4 screws M3x6 DIN7985
M3x6
screw
Washer
Fittings
All
disclosures,
notices
and
warranty
conditions
are
being
written
on
the
back
of
the
box.
Released
on
1
st
of
February,
2010.