Revision 1.0. Released on 20
th
of November, 2012.
Installation and mounting manual for
EK-DBAY DCP 2.2 (Original CSQ incl.
pump)
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at
installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
Before you start using this product please follow these basic guidelines:
1.
Please carefully read the manual before through before beginning with the installation process!
2.
The EK High Flow and EK-PSC type fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o-ring gaskets.
3.
The use of quality, market proved corrosion inhibiting coolants is always strongly recommended for any liquid cooling system.
STEP 1: GENERAL INFORMATION.
Sample picture of EK-DBAY DCP 2.2 (Original CSQ incl. pump)
STEP 2: MOUNTING THE RESERVOIR INSIDE YOUR COMPUTER CHASSIS:
This reservoir occupies two 5.25” drive bay expansion slots in your computer chassis. Free two slots in case they are already occupied with other
computer components such as optical- or hard disk drives:
1)
Install anti-vibration rubber damper into each of the three slots on the sides of the reservoir
2)
Place the reservoir in your 5.25" drive bay with the front plate facing outwards
3)
Secure the reservoir to the drive bay cage using the enclosed M3x4 DIN7985 screws and Philip head screwdriver.
M3x4 DIN7985 screw
M3 BAY anti-vibration
rubber damper
