13
STEP 6
USE AND CUTTING OF PRE-BENT TUBES FOR ALIGNING
CPU BLOCK TUBES WITH DISTRIBUTION PLATE
Once you have measured the vertical variance, cut the tube according to the
following instructions:
Variance mm / Inch
Cut following length of the short end
bend (1st CUT):
5mm (0.2”)
41mm (1.6”)
6mm (0.24”)
35mm (1.4”)
7mm (0.28”)
29mm (1.14”)
8mm (0.31”)
24mm (0.95”)
9mm (0.35”)
18mm (0.7”)
10mm (0.39”)
12mm (0.5”)
11mm (0.43“)
6mm (0.24”)
12mm (0.47”)
Don’t cut anything on this end
Use the miter tool to cut the tube straight.
When measuring the length of the tube, please follow these steps:
1. Measure the horizontal distance from the Distribution Plate surface to the
center of the CPU block fitting.
2. Deduct from that length 16 mm (0.63“).
3. Cut the tube at that length.
Vertical variance:
1st CUT:
6 mm (0.24")
12 mm (0.5")
18 mm (0.7")
24 mm (0.95")
29 mm (1.14")
35 mm (1.4")
41 mm (1.6")
5 mm (0.2")
6 mm (0.24")
7 mm (0.28")
8 mm (0.31")
9 mm (0.35")
10 mm (0.39")
11 mm (0.43")
12 mm (0.47") - dont cut
STEP 6
STEP 6 First Cut
Miter Tool
STEP 6
If vertical
distance is
bigger than
5 mm
Distribution Plate
CPU Block
First Cut
Second Cut
STEP 6 Second Cut
Miter Tool
[Horizontal distance] - [16 mm (0.63”)]
V. Final Assembly
