- 14 -
STEP 4
The saved I/O Fan Cover can be also reused and attached using
M2 x 3 Screws (From Chapter: PREPARING THE MOTHERBOARD;
STEP 2).
STEP 4
SCREW M2 x 3 (2x)
I/O FAN COVER
For this step you will need:
Phillips Head Screwdriver
FITTINGS AND TUBING
STEP 1
With the EK-Quantum Momentum
2
ROG Strix Z690-i D-RGB water
block, it is mandatory to use the bottom port as the INLET. Mixing
the ports may result in poor thermal performance of the water block.
Tighten the fittings in a clockwise direction until the gasket
underneath is compressed.
The installation of the water block is now complete.
STEP 1
TUBING
IN OUT
EK-FITTING