- 7 -
INSTALLING THE WATER BLOCK ON RTX 2080/RTX 2080 TI GRAPHICS CARD
STEP 1
PLACING THE WATER BLOCK ON THE GRAPHICS CARD
Carefully position the water block with preinstalled standoffs on
the graphics card. During this process, please make sure you have
aligned mounting holes on the PCB with holes on the water block
(same applies to other tops).
Pay attention not to use too much force when pressing the
block down to the PCB since chip dies are prone to cracking.
This procedure is the same for all Full Cover water blocks.
STEP 2
ATTACHING THE BLOCK TO THE GRAPHICS CARD
Use a Phillips head screwdriver with the enclosed M2.5 x 4 AX1
screws. EK recommends you start tightening the screws around
the GPU core and continue outward. Always use a plastic washer
under each screw! If the washer is already present on the circuit
board (usually around GPU core screw-holes), there is no need for
additional washers.
For this Step, you will need:
Phillips-head
screwdriver
M 2.5x4 AX1
12 pcs
M 2.5 PVC washer
12 pcs
M2,5x4 AX1
STEP 1
STEP 2
