14
EKOSync 1588 User Manual rev 3.10
Hardware Installation
1. Install the antenna in a location with a clear sky view.
2. Install the EKOSync 1588 in the desired location and connect to the antenna.
3. Connect the EKOSync 1588 to the network switch.
4. Connect to power, ensuring the correct DC voltage (18 - 75VDC) is used.
5. Connect the Sync indication relay to the alarm circuit if required.
(C = Common, NO = Normally Open, NC = Normally Closed)
6. Once the EKOSync 1588 is installed and configured, connect the clock outputs to your devices.
– An RG58 cable is recommended to connect devices to the output ports.
– A termination resistor of 120 Ω can be added to the end of a TTL run to achieve good
impedance matching.
