EKOM DK50 2x4VR/110/M, Руководство пользователя

Страница: 47 / 168

PRODUCT MAINTENANCE
09/2020 47 NP-DK50 2x4VR 110-AD-A-1_09-2020

Connect the cabinet to the compressor by inserting the power cord with connector into a power
socket. (Fig. 18)

Connect the device to the electrical mains

Activate the compressor by turning on the switch on the pressure switch and the switch (4) on
the cabinet (Fig. 20).
Compressor with cabinet - when operating in the cabinet, there must not be an electrical
connection. (Fig. 24 pos A).
Note: In case of using a compressor without a cabinet or in case of maintenance, a jumper
which is not installed into the terminal strip should be kept in a designated place next to the
electrical panel.
18.10. Cleaning and disinfection of the exterior surfaces of the product
Clean and disinfect the exterior surfaces with neutral cleaning products.
Use of aggressive detergents and disinfectants containing alcohol and chlorides
can lead to surface damage and discolouration.
AD dryer maintenance
18.11. Venting pressure from the dryer
The equipment is designed to permit the safe venting of pressure within 10 seconds after the
compressor is shut off.
If pressure is not automatically vented from the dryer, then the pressure may be vented manually.
Venting compressed air poses an injury hazard
Wearing hearing protection is recommended given the noise generated by the
venting process.
Shut off the compressed air source before venting pressure from the equipment
Venting pressure using the display screen
Press ESC+▼ in the display screen to vent pressure from the equipment.

First, shut off the compressed air source.

Then press and hold ESC+▼, which will open all the solenoid valves (inlet and regeneration) for
10 seconds and then vent the pressure from the equipment and connected pneumatic circuits
and elements that are not separated from the equipment by the check valve
Manual venting of pressure

Turn off the compressor.

Open the vent plugs on the outlet module on the equipment (Fig. 25).