EKOM ASPINA DO M, Руководство пользователя

Страница: 28 / 196

PRODUCT MAINTENANCE
NP-DO M-39_12-2021 28 12/2021
14.9. Replacing the filter in the separation vessel
1 2 3
Fig. 2: Replacing the filter in the separation vessel
LONG-TERM SHUTDOWN
When the dental suction equipment is not used for a longer time, it is necessary to carry out the
cleaning and disinfection of all parts as described in the Articles No. 14.2, 14.4 and then turn the
power-
supply switch (5) on in the position “I”, take the suction tubings (6) off the holder (2) and let
the air intake flow through (for approximately 15-20 min) so that the suction system is fully dried out.
Afterwards put the tubings into the holder and turn off the power-
supply switch in the position “0”,
disconnect the equipment from the network (unplug) and remove the suction mouthpieces (1) from
suction tubings.
DISPOSAL OF DEVICE

Disconnect the appliance from mains.

To follow the rules of personal hygiene for works with contaminated material

Clean device according, section 14.

To separate, label, packing and providing for decontamination of contaminated parts by course
of national regulations.

Dispose of the product following all locally applicable regulations.
Danger of biological hazard and environmental pollution.
Internal parts of the suction equipment may be contaminated with biological
material. Hand over the device to a specialised organisation for decontamination
before separating and disposing of the unit.