EKKO EP20D Series, Руководство пользователя

Страница: 24 / 27

21
10.4.4 Faults and defects:
the management must be notified immediately if the vehicle has
a fault or defect. If the vehicle can't operate safely (e.g., wheels are worn down or brakes are
faulty), then be sure to stop using them until they are fully repaired.
10.4.5 Safe operation and environmental protection:
the contents of inspection and
maintenance must be performed according to the time interval on the maintenance list.
The parts on the vehicle, especially safety devices, shall not be changed without permission,
and the operating speed of the vehicle shall not be changed.
All the spare parts of the original factory have been verified by the quality assurance
department. In order to ensure the safety and reliability of the vehicle operation, the spare
parts of the manufacturer must be used only. Replacement parts such as oil and fuel must be
processed in accordance with the appropriate environmental protection rules.
10.4.6 Danger zone: the danger zone usually refers to the following areas:
the area
where the load lifting device (such as cargo fork or accessories) of the carrier is dangerous
to the personnel during operation or lifting action, or the area where the load is being
transported. Usually this range extends to the area where the payload or vehicle attachment
lands.
Unauthorized personnel must be required to leave the danger area .As long as the person
may cause some kind of injury, the driver must give the warning, if the driver failed to ask
the person leaving the danger zone, the driver must immediately stop the vehicle
10.4.7 high-risk environment:
when working in high-risk environment, special design
must be adopted to protect it.
The car is not specifically designed for high-risk environments.
10.4.8 safety devices and warning signs:
safety devices, warning signs and warning
notices described in the operation manual must be given sufficient attention.
10.4.9 driving in public places:
cars are prohibited from driving in public places except
special areas.
10.4.10 distance between vehicles:
keep in mind that the vehicle ahead may suddenly stop
at any time, so keep a proper distance.
10.4.14 operation management:
the driving speed must be adapted to local conditions.
Vehicles must travel slowly when passing through curves, narrow passages, revolving doors,
and in unobstructed areas. The driver must be able to visually detect sufficient braking
distance between the vehicle and the vehicle in front of him, and he must always control his