20
10.3.2
New vehicles have been equipped with lubricating oil and hydraulic oil in the fuel
tank.
10.3.3
Storage battery for the moving vehicle.The battery has been charged at the factory.If
the factory is long, the power may be low.Attention should be paid to the display of the
electric meter before use. When the electric meter is shown to the last two bars of warning,
it must be charged immediately.Open the battery cover every day before use or before
charging. Check the level. If the level is too low, distilled water should be added before
charging.See (battery charging and maintenance) for details.
10.4 Safe Operation
10.4.1
Requirements for drivers: the vehicle must be operated by trained personnel;
10.4.2 Rights, obligations and duties of the driver:
the driver must clarify his rights and
obligations and have been trained in the operation of the vehicle;Be familiar with the
operation manual.If the vehicle is pedestrian controlled, the driver must also wear safety
boots while operating.
10.4.3The use of unauthorized personnel shall be prohibited:
the driver shall be
responsible for the vehicle during the working period, and he must prevent the
unauthorized personnel from driving or operating the vehicle.It is strictly prohibited to use
vehicles to transport or promote personnel.
10.4.4 Faults and defects:
the management must be notified immediately if the vehicle has
a fault or defect.If the vehicle can't operate safely (e.g., wheels are worn down or brakes are
faulty), then be sure to stop using them until they are fully repaired.
10.4.5 Safe operation and environmental protection:
the contents of inspection and
maintenance must be performed according to the time interval on the maintenance list.
The parts on the vehicle, especially safety devices, shall not be changed without permission,
and the operating speed of the vehicle shall not be changed.
All the spare parts of the original factory have been verified by the quality assurance
department. In order to ensure the safety and reliability of the vehicle operation, the spare
parts of the manufacturer must be used only.Replacement parts such as oil and fuel must be
processed in accordance with the appropriate environmental protection rules.
10.4.6 Danger zone: the danger zone usually refers to the following areas:
the area
where the load lifting device (such as cargo fork or accessories) of the carrier is dangerous
to the personnel during operation or lifting action, or the area where the load is being
Содержание EP18LI Series
Страница 12: ...9 6 Electrical Schematic Diagram...
Страница 13: ...10 7 Hydraulic Schematic Diagram...
Страница 18: ...15 Replace the hydraulic filter...
