Applicatio Manual
Universal Interface 4 DIN/NTC EK- CG2-TP
Revisione 1.0.0 - Aggiornato: 04/09/2017
© SBS S.p.A.
– Tutti i diritti riservati
MAEKCG2TP_EN
Pag. 69
9.8
Scenes
The folder allows the scenes configuration (up to 8), assigning to each one an identification number and the operating
mode to be activated when recalled (e.g. with an ekinex pushbutton or another KNX device with this function). If
Learning
mode = enabled
, receiving a telegram of scene storage determines the association of the scene to the operating mode
currently set on the Touch&See unit.
Important!
Be careful setting the
Download overwrite
parameter. The download of the application program, particularly
after the first commissioning of the system, may cause the loss of the already stored scenes.
The
Scenes
folder includes the following parameters:
•
Download overwrite
•
Scene X
•
Scene number
•
HVAC mode
•
Activation delay
•
Learning mode
Condition:
Temperature control
Settings Scenes = enabled.
9.8.1 Parameter and communication object tables
Parameter name
Conditions
Values
Download overwrite
disabled
/ enabled
If Overwrite download = disabled: at the download of the application
on the device, the operating modes previously stored are not
overwritten.
If Overwrite download = enabled: at the download of the application
on the device, the operating modes previously stored are
reprogrammed with the values selected from the HVAC mode
parameter.
Scene X
disabled
/ enabled
This parameter enables the scene X (X = 1, 2, … 8).
Scene number
Scene X = enabled
1
[range 1 … 64]
HVAC mode
Scene X = enabled
auto /
comfort
/ standby / economy
/ building protection
This parameter defines the operating mode of the scene X.
Activation delay
Scene X = enabled
hh:mm:ss (
00:00:00
)
Receiving a telegram that recalls a scene, once elapsed the time
interval set in the Activation delay parameter, the programmed
operating mode is activated.
Learning mode
Scene X = enabled
disabled
/ enabled