Technical Information CV1-AMBIENT • CPCI Graphics Adapter
- 13 -
EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany)
Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail [email protected] * Internet http://www.ekf.de
Technical Reference - Jumper Fields and Connectors
Caution
Some of the connectors provide operating voltage (e.g. 5V and 12V) to devices inside the
system chassis, such as fans and internal peripherals. Not all of these connectors are overcurrent
protected. Do not use these connectors for powering devices external to the computer chassis.
A fault in the load presented by the external devices can cause damage to the board, the
interconnecting cable and the external devices themselves.
Jumper Fields
Jumper Fields DispConfA and DispConfB
The jumper fields DispConfA and DispConfB can be used to pass over configuration settings of
the primary display port to the BIOS firmware. With future releases of the BIOS, settings
described here could change.
DispConfA
DispConfA is intended to allow configuring of the resolution of the graphics controller to match
an attached TFT-display. Currently it is not in use. Therefore
factory default is all jumpers
removed
- do not change this setting unless a newer BIOS explicitly allows differing
configuration.
All jumpers removed from DispConfA enables DispConfB (see next page)
