EK ShowPro LEDPRO132, Руководство пользователя, Страница: 5 / 16

5
MAINTENANCE
MAINTENANCE AND CLEANING THE UNIT
• Make sure the area below the installation place is free from unwanted persons during setup.
• All screws used for installing the device and any of its parts should be tightly fastened and should not
be corroded.
deformation.
• The main cables must be in impeccable condition and should be replaced immediately even when a
small problem is detected.
• It is recommended to clean the front at regular intervals, from impurities caused by dust, smoke, or
other particles to ensure that the light is radiated at maximum brightness. For cleaning, disconnect the
main plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then carefully wipe
the part dry. For cleaning other housing parts use only a soft, clean cloth. Never use a liquid, it might
penetrate the unit and cause damage to it.
TROUBLESHOOTING
Problems Possible causes Checks and remedies
Fixture does not light up
•
No mains supply
•
Dimmer fader set to 0
•
Faulty LED
•
Faulty LED board
•
Check the power supply voltage
•
Increase the value of the dimmer channels
•
Replace the LED board
•
Replace the LED board
General low light intensity
•
Dirty lens assembly
•
Misaligned lens assembly
•
•
Install lens assembly properly
Fixture does not power up
•
No power
•
Loose or damaged power cord
•
Faulty internal power supply
•
Check for power on power outlet
•
Check power cord
•
Replace internal power supply
Contact an authorized service center in case of technical problems or not reported in the table can not be
resolved by the procedure given in the table.
FUSE REPLACEMENT
1. Disconnect this product from the power outlet.
2. Using a screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a good fuse of the same type and rat-
ing (250V/T3.15A).
4. Screw the fuse holder cap back in place and reconnect power.
12
DMX CHARTS
5CH Function Value Percent/Setting
1 Dimmer 000-255 0~100%
2 Dimmer Fine 000-255 0~100%
3
Color
Temperature
000-000 0
001-255 -25~25
000-010 No Function
011-255 Strobe slow to fast
4 HUE
5 Strobe
Refer to 3CH CHART
6CH Function Value Percent/Setting
1 Red 000-255 0~100%
2 Orange 000-255 0~100%
3 Green 000-255 0~100%
4 Royal Blue 000-255 0~100%
5 Blue 000-255 0~100%
6 Lime 000-255 0~100%
8CH Function Value Percent/Setting
1 Dimmer 000-255 0~100%
2 Red 000-255 0~100%
3 Orange 000-255 0~100%
4 Green 000-255 0~100%
5 Royal Blue 000-255 0~100%
6 Blue 000-255 0~100%
7 Lime 000-255 0~100%
000-010 No Function
011-255 Strobe slow to fast
8 Strobe